#How to replace a dishwasher drain hose free#

Once it’s out of the way, remove the two screws holding the drawer’s housing. Then slide the top panel back an inch and lift it free. Move to the back of the washer and loosen the screws holding the brackets to the rear access panel. Īfter that, get the top panel out of the way. Loosen the two screws holding the lid switch in place and then push it into the machine. Now you can peel the right side of the boot seal out of the way to remove the door switch. Just pry it out with a flathead screwdriver and set it aside. This is under the first rubber edge of the outer boot seal. Next, open the washer door and pry up the boot seal clamp. Once the housing is out of the way, you can remove the screw that holds the front panel of the washer to the frame. Then remove the housing by loosening the screw in the bottom.

#How to replace a dishwasher drain hose free#

Pull the pump drain hose free and then remove the hose cap. Release the locking tabs on the door hinges and set the door aside. įirst, open the pump filter compartment in the bottom left corner of the washer. You will need to remove a lot of different parts before you can remove the front access panel. If there isn’t room where you washer usually sits, disconnect the water supply lines and the drain hose so you can move the washer. ĭuring the repair, you will also need to tilt the machine back. For this repair, you also need to shut off the water supply to prevent the risk of a leak as you remove the drain hose. Unplug the washer and turn off the water.Īlways unplug an appliance before you start making repairs. Order part #5215EA4001G for a drain hose for your front-loading LG washer.

Once the drain hose is torn, you have to replace it. If you see water draining near the front of the machine, the drain hoses around the tub might be at fault. Leaks are one of the most common problems with washers, and they can be one of the most damaging problems if you don’t immediately notice.